Once complete, select the option to Reboot if presented.Select Factory Reset and press Enter again: You will see the Image that will be used to perform the factory reset.Arrow down to Factory Reset and press Enter to display the menu.Once in maintenance mode, the following is displayed, please press enter to continue.Please choose PANOS (maint). Press enter to continue. you will see a “CHOOSE PANOS” screen with the following options: PANOS (maint-other), PANOS (maint) or PANOS (sysroot0).Type maint and hit Enter to enter maintenance mode.PANOS (maint-sysroot0) PANOS (maint-sysroot1) PANOS (sysroot0) PANOS (sysroot1) The options below will show for 5 seconds only Select PANOS (maint-sysroot1) from the options below.During the boot sequence, the screen should look like this.NOTE: A USB-to-serial port will have to be used if the computer does not have a 9-pin serial port. Connect the Console cable, which is provided by Palo Alto Networks, from the “Console” port to a computer, and use a terminal program (9600,8,n,1) to connect to the Palo Alto Networks device.I deleted some content here.ĭirectory of flash:/10/ġ27 -rwx 230262 10Īp: boot flash:/10/10/Īnother way is to use the following command.Ĭisco IOS Software, C3600 Software (AP3G2-K9W8-M), Version 15.3(3)JF10, RELEASE SOFTWARE (fc3) We can use the dir command to confirm the directory and filename in the flash before starting with the boot command. Tftp_init success: You can now use tftp file system! Set the IP addressĪp: set DEFAULT_ROUTER 10.106.32.1 2. The following is the upgrade process, I used an AIR-CAP3602I-A-K9. Then use the following command to upgrade the IOS AP. Press the ESC button during AP startup to enter ROMMON mode.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |